Using ENESEAL^® HR

Surface Preparation - ENESEAL^®CR should only be applied to clean, dry and structurally sound surfaces. Surfaces should be free of any loose material and all contaminants such as dirt, oil, grease, salt, loose or flaking paint, etc.

...for metal surfaces
While abrasive blasting is not necessary, all areas to be treated should be manually prepared to SSPC SP-2 or SP-3 by grinding, rotary wire brushing or other appropriate means to remove loose rust, scale, or previously applied coatings. Alternatively, high pressure water jetting in accordance with SSPC SP-12 to a minimum visual condition of WJ-4 has been found very effective on large areas to achieve the desired surface prior to application.

...for cementitious surfaces
High pressure water jetting or light abrasive blasting have generally been found to be the most effective means of removing loose material and the typically weak surface layer often encountered when preparing concrete/mineral substrates.

Mixing - ENESEAL^®CR is a one component product which should be stirred slowly prior to application in order to blend in any slight separation.

Thinning of ENESEAL^®CR with water or solvent is not recommended.

Application - ENESEAL^®CR should only be applied when the temperature is above 45 F (7 ) and when the relative humidity is below 85%. Surfaces being treated should be at least 5 F (3 C) above the dew point.

ENESEAL^®CR may be applied by brush, roller or spray. The material should be applied at a wet film thickness of approximately 12 - 14 mils (300 - 350 microns) to achieve the desired dry film thickness of 7 - 8 mils (175 - 200 microns) per coat. A minimum of two coats are recommended for most applications.

Health & Safety - Every effort is made to insure that ENECON^® Products are as simple and safe to use as possible. Normal industry standards and practices for housekeeping, cleanliness and personal protection should be observed. Please refer to the detailed MATERIAL SAFETY DATA SHEET (MSDS) supplied with the material (also available on request) for more information.

Cleaning Equipment - Wipe excess material from tools and equipment immediately. Use soap and water as needed.

Technical Support - The ENECON^® engineering team is always available to provide technical support and assistance.

For guidance on difficult application procedures or for answers to simple questions, call your local ENECON^® Fluid Flow Systems Specialist or the ENECON^® Engineering Center.

All information contained herein is based on long-term testing in our laboratories as well as practical field experience and is believed to be reliable and accurate. No condition or warranty is given covering the results from use of our products in any particular case, whether the purpose is disclosed or not, and we cannot accept liability if the desired results are not obtained.

Copyright © 2008 by ENECON^® Corporation. All rights reserved. No part of this work may be reproduced or used in any form or by any means - graphic, electronic or mechanical including photocopying, recording, taping or information storage and retrieval systems - without written permission of ENECON^® Corporation.