|
Application - The substrate should be
structurally sound and free of any coatings, sealants, or
surface contaminants such as dirt, grease, oil, etc. For optimum
penetration, ENESEAL® MP should only be applied to dry surfaces
and should never be applied where liquid water is present. All
joints should be caulked and all caulking should be allowed to
cure before applying ENESEAL® MP.
ENESEAL® MP is ready to use, as supplied; however, the material
should be stirred / agitated before application. Thinning or
adding any other material is neither required nor recommended.
ENESEAL® MP should be applied to vertical surfaces from the
bottom up in a single flooding coat to produce a 6 inch (15 cm)
rundown. On extremely porous substrates, a second coat should be
applied after the initial flood coat has been allowed to
penetrate for about 5 minutes.
On horizontal surfaces, ENESEAL® MP should be applied in a
single saturating coat until rejection. Surface puddles should
be brushed out until they completely penetrate the surface. Any
ENESEAL® MP that remains on the surface for longer than 10
minutes should be re-distributed to another area.
ENESEAL® MP may not be suitable for all masonry surfaces such as
gypsum, some types of natural stone and sealed or painted
surfaces. In addition, some surfaces may darken slightly due to
the density / porosity / texture of the substrate. In such
situations, a test application should be carried out in a
relatively unnoticeable area.
Do not apply ENESEAL® MP in direct sunlight when temperatures
are over 90° F / 32° C. Do not apply if the temperature is below
35° F / 1° C, or if frost or ice is present.
Keep overspray off surrounding surfaces and away
from plants and shrubbery nearby.
Health & Safety - Every effort is made to insure that
ENECON® Products are as simple and safe to use as possible.
Normal industry standards and practices for housekeeping,
cleanliness and personal protection should be observed. Please
refer to the detailed MATERIAL SAFETY DATA SHEET (MSDS) supplied
with the material (also available on request) for more
information.
Cleaning Equipment - Clean tools, equipment and
overspray, while wet, with warm soapy water. Dried residue can
be cleaned with solvents such as mineral spirits or alcohol.
Technical Support - The ENECON® engineering team is always available to provide technical support and assistance.
For guidance on difficult application procedures or for answers to simple questions, call your local ENECON® Fluid Flow Systems Specialist or the ENECON® Engineering Center. |
|
All information contained herein is based on long-term testing in our laboratories as well as practical field experience and is believed to be reliable and accurate. No condition or warranty is given covering the results from use of our products in any particular case, whether the purpose is disclosed or not, and we cannot accept liability if the desired results are not obtained.
Copyright © 2009 by ENECON® Corporation. All rights reserved. No part of this work may be reproduced or used in any form or by any means - graphic, electronic or mechanical including photocopying, recording, taping or information storage and retrieval systems - without written permission of ENECON® Corporation. |
